Table of Contents
how to use molle attachments

how to use molle attachments
Introduction
The MOLLE system is a great way to customize your gear, but there’s nothing worse than having an attachment that doesn’t fit properly.
Molle gun holster
A molle gun holster is a tactical gun holster that is used to carry a gun in a more secure and comfortable manner. This holster is made of high-quality materials and is designed to provide a more comfortable and secure fit for the gun. The holster is also adjustable to fit different sizes of guns. The Molle gun holster is a great choice for those who want a more secure and comfortable way to carry their gun.
Locate the vertical straps of webbing on the MOLLE-equipped gear.
Locate the vertical straps of webbing on the MOLLE-equipped gear.
MOLLE attachments are located on the outside of your gear and may be found in several different places, including:
- Front (for example, a chest rig or plate carrier)
- Sides (for example, a vest)
- Back (for example, a backpack)
Remove the plastic slider that is located in the center of these straps.
The plastic slider is a small piece of plastic that holds the strap in place. It’s usually found in the middle of your molle attachment, and it will typically be a different color than your straps.
To remove this little piece, simply use a small flathead screwdriver or other similar tools to pry it out from under where you can see it at all times during installation (a good way to do this is by placing one hand on top of another).
Pull the strap back through the loops of webbing until it is completely flat.
Once you’ve made the attachment point, pull the strap back through the loops of webbing until it is completely flat. You should be able to see where your attachment point ends and where your molle loop starts.
Place the pouch that you would like to attach to your MOLLE gear next to it, with its attached straps hanging down in a horizontal manner.
- Place the pouch that you would like to attach to your MOLLE gear next to it, with its attached straps hanging down in a horizontal manner.
- If necessary, pull out some of the excess straps from underneath the pouch by pulling on one of its corners. This will allow you to see what kind of attachment system is inside and how wide it is.
Find the strap from one side of the pouch.
The strap from one side of the pouch should be fed up through both loops on the bag, then down through one loop on your molle equipment. You’ll need to repeat this step with all vertical straps on your molle equipment.
Use a pair of scissors or a knife to trim off any excess webbing that may be sticking out too far from a loop.
Use a pair of scissors or a knife to trim off any excess webbing that may be sticking out too far from a loop. This can be done by cutting along the top of the velcro strip and then across it, as shown in this photo:
Don’t worry if you mess things up, you can always start over!
You can always start over, but don’t worry if you mess things up. If you make a mistake, just start over again! Sometimes it’s easy to get frustrated when we’re learning something new and feel like our efforts aren’t paying off immediately. That’s normal—but don’t let that stop you from trying again until the next time your project is due.
Conclusion
In conclusion, molle attachments can be a great tool for your MOLLE gear. They allow you to attach storage pouches, ammo cans, and much more. If you’re looking for some great new additions to your tactical loadout then consider getting some of these products so that they can help you out on the battlefield!